SEEKINS PRECISION 34MM SCOPE RINGS
$159.00
- Machined from 7075-T6 aluminum in serialized pairs to the most exacting standards in the industry, Seekins Scope Rings never need to be lapped or altered in any way.
- Scope Rings are .8” wide (4 screw cap) to provide more clamping surface area than any other ring on the market.
- Smooth edges and radiuses make Seekins Scope rings snag free and will not hang up when deploying from drag bags or scabbards.
- All rings are Type III Hardcoat Anodized matte black for a durable non-glare finish.
- Built to the 1913 Picatinny specification, Seekins Precision Scope Rings have a center lug machined directly into the bottom.
- This integral, flat recoil lug is far superior to cross bolt lug designs and fits precisely into Picatinny slots with minimal clearance.
- For maximum torque and strength, Grade 8 T-25 Torx® fasteners are used that will not strip out while being tightened to the appropriate specification.
Ring Heights
Low - .92"
High - 1.0"
Torque Spec:
**INCH LBS** 15-25 INCH LBS for the Cap screws and 55 INCH LBS for the Clamp Screws.
*IF LOWER* use your scope manufacture's recommended ring cap torque